X-Carve Bit Storage (2of3)
Project by
Chip Clark
General Information
This is the second of my X-carve tool and accessory holders and is a modification of the one published by Julien Hoffmeyer. 3/4" MDF and I used a 1/4" round over bit in the router table to finish the top edge
Open in Easel®
These are fantastic, I've carved all three pieces. They fit perfectly in my dedicated X-Carve drawer. Thanks for sharing!
Matt Slaga
Carved #1 trying to Carve #2. will not move on to confirm bit? an you suggest something I might be doing wrong?
Keith Lake